I wanted to do the simulation that a line source of sine wave propagates through air to sensor,and I found out that whether defining the properties of the propagation medium(sensor) on sensor had a big difference. For instance, I defined the properties of the propagation medium(sensor) on senor, the pressure value was up to 30~40 Pa(Initially I set 5 Pa); I defined the properties of the propagation medium(sensor) in front of senor, the pressure value was down to 2~3 Pa; I defined the properties of the propagation medium(sensor) behind senor, the pressure value was up to 10 Pa. If I didn't define any medium then the pressure value is close to 5 Pa, so now I want to figure out why I define the medium appearing these phenomena?
k-Wave
A MATLAB toolbox for the time-domain
simulation of acoustic wave fields
meduim setting problems
(2 posts) (2 voices)-
Posted 5 years ago #
-
Hi Cheng-You Lee,
Are you just seeing changes in the wave amplitude due to different transmission coefficients into the step-change in medium properties, or in one of the cases, a reflection?
Brad.
Posted 5 years ago #
Reply
You must log in to post.