Dear Bradley,
I am trying to run a nonlinear simulation with a circular transducer in 3D where the sourc is 2.5 cm in diameter and the center freuqency is 2.25 MHz. i would like to do so until 20 cm away from the source, but so far i have been only able to achieve 10 cm. Is it perhaps possible to use the results of the previous simulation to launch a new one?
Thanks!
Kind regards,
Anastasiia.
k-Wave
A MATLAB toolbox for the time-domain
simulation of acoustic wave fields
out of memory, next simulation with the initial conditions of the previous one
(2 posts) (2 voices)-
Posted 4 years ago #
-
Hi Anastasiia,
This can be done, but does lead to some small errors. See this thread for discussion and code examples (at the end of the thread), and also this paper.
Brad.
Posted 4 years ago #
Reply
You must log in to post.